How do I reconfigure the region layout of my keyboard?

Configuration question
1

Hi, I’m not sure if this is a bug or a config error, but I noticed that two of my LEDs are not lighting up in any layer incl. base layer at any color and any brightness. They are however clearly not defective, when I reset my UHK80 they do light up for a second. The affected LEDs are under the left shift key and under the “<>” key next to it. However the LED in between is lighting up. In Agent, I can see that my board is apparently configured to be in a US ANSI layout, where there is just one big shift key is there - so it makes sense it’s only lighting up that one LED in the middle. How do I change my config to be aware of the physical key layout? I didn’t find any setting for that.

Also, a minor bug: in Agent some keys, like the mouse buttons on the trackball module have a configurable RGB color even though they have no physical LEDs.

2

See the advanced settings section in Agent: How to retrieve UHK 80 logs - Ultimate Hacking Keyboard

Besides logging, there should be an ansi/iso toggle at the top :wink:.

2 Likes
3

Also, a minor bug: in Agent some keys, like the mouse buttons on the trackball module have a configurable RGB color even though they have no physical LEDs.

An interesting observation.

When per key rgb is on, firmware actually requires the rgb to be present, although, ideally Agent should not shiw them as colorable :thinking:.

4

Nice thanks!